Set up the swap
Open Ramp Network through the wallet or website you are using and select Swap, where offered.
Select the crypto and network you will send, then the crypto and network you want to receive.
Enter the amount and review the estimated output and fee breakdown.
Follow the prompts for your sending and receiving wallet details and any verification. If the partner already supplies a wallet address, check the displayed address and network; you do not need to type it again unless asked.
Confirm the swap details and follow the instructions to send your crypto.
The sending address identifies the wallet you will transfer from. The receiving address is where the swapped crypto will go. You can use the same address for both only if your wallet supports the selected assets on both networks; matching-looking addresses alone do not establish support.
Send your crypto
Use the exact asset, network, address and amount shown for the swap. Include a memo or destination tag if shown, even if your wallet calls that field optional. Leave enough funds for the sending walletâs network or withdrawal fee.
For example, if you selected USDC on Arbitrum as the sending asset, send USDC on Arbitrum. Do not send it on another network.
Return to the transaction page after sending. Ramp Network receives and confirms the transfer, processes the swap and sends the resulting crypto to your receiving wallet. Status updates and emails help you follow receipt and delivery.
Most straightforward swaps finish within a few minutes after Ramp Network receives the crypto, but network congestion, verification or technical issues can extend this.
Why canât I swap?
Swaps are not available in the European Union (EU). Outside the EU, availability depends on your location, account and the supported service. Check the options offered for your transaction.